| Cruise control cannot be set |
- Check horn operation.
- 2000-03 models: Check cruise control set/decel, resume/accel switch (see CRUISE CONTROL SET/DECEL, RESUME/ACCEL SWITCH TEST/REPLACEMENT ).
- 2004-05 models: Check cruise control set/decel, resume/accel, cancel switch (see CRUISE CONTROL SET/DECEL, RESUME/ACCEL SWITCH TEST/REPLACEMENT ).
- Test the brake pedal position switch (see BRAKE PEDAL POSITION SWITCH TEST
) and check its adjustment (see ABS MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION
).
- Test clutch pedal position switch (see CLUTCH PEDAL POSITION SWITCH TEST ) and check its adjustment (see CLUTCH PEDAL, CLUTCH PEDAL POSITION SWITCH, AND CLUTCH INTERLOCK SWITCH ADJUSTMENT
).
- Do the cruise control unit input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
- Blown No. 6 (15 A) fuse in the under-dash fuse/relay box
- Blown No. 47 (2000-03 models: 10 A, 2004-05 models: 15 A) fuse in the main underhood fuse/relay box
- Poor ground: G301, G401, G402
- Open circuit, loose or disconnected terminals: BLK/YEL, LT GRN, LT GRN/RED, GRY, ORN, WHT/BLK
|
| Cruise control can be set, but the cruise control indicator does not come on |
- 2000-03 models: Check dimming circuit in gauge assembly (see CIRCUIT DIAGRAM
).
- 2004-05 models: Check dimming circuit in gauge assembly (see CIRCUIT DIAGRAM
).
- Do the cruise control unit input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
- Poor ground: G501
- Open circuit, loose or disconnected terminals: BLU/YEL
|
| Cruise speed is noticeably higher or lower than what was set |
- Check vehicle speed sensor (VSS) (see VEHICLE SPEED SIGNAL CIRCUIT TROUBLESHOOTING
).
- Check cruise control actuator and cable adjustment (see CRUISE CONTROL ACTUATOR TEST ).
- Do the cruise control unit input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
|
| Excessive overshooting or undershooting when trying to set speed |
- Check vehicle speed sensor (VSS) (see VEHICLE SPEED SIGNAL CIRCUIT TROUBLESHOOTING
).
- Check cruise control actuator and cable adjustment (see CRUISE CONTROL ACTUATOR TEST ).
- Do the cruise control unit input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
|
| Speed fluctuates on a flat road with the cruise control set |
- Check vehicle speed sensor (VSS) (see VEHICLE SPEED SIGNAL CIRCUIT TROUBLESHOOTING
).
- Check cruise control actuator and cable adjustment (see CRUISE CONTROL ACTUATOR TEST ).
- Do the cruise control unit input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
|
| Vehicle does not decelerate or accelerate accordingly when the set/decel or resume/accel switch is pressed |
- 2000-03 models: Check cruise control set/decel, resume/accel switch (see CRUISE CONTROL SET/DECEL, RESUME/ACCEL SWITCH TEST/REPLACEMENT ).
- 2004-05 models: Check cruise control set/decel, resume/accel, cancel switch (see CRUISE CONTROL SET/DECEL, RESUME/ACCEL SWITCH TEST/REPLACEMENT ).
- Do the cruise control unit input test (see CRUISE CONTROL SET/DECEL, RESUME/ACCEL SWITCH TEST/REPLACEMENT ).
|
Open circuit, loose or disconnected terminals: LT GRN/RED, LT GRN/BLK |
| Set speed does not cancel when the brake pedal is pressed |
- Test the brake pedal position switch (see BRAKE PEDAL POSITION SWITCH TEST
) and check its adjustment (see ABS MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION
).
- Do the cruise control unit input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
Short to power in the GRY wire |
| Set speed does not cancel (engine RPM stays high) when the clutch pedal is pressed |
- Test clutch pedal position switch (see CLUTCH PEDAL POSITION SWITCH TEST ) and check its adjustment (see CLUTCH PEDAL, CLUTCH PEDAL POSITION SWITCH, AND CLUTCH INTERLOCK SWITCH ADJUSTMENT
).
- Do the cruise control unit input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
Short to ground in the PNK wire |
| Set speed does not cancel when the cruise control main switch is turned off |
- Check cruise control main switch (see CRUISE CONTROL MAIN SWITCH TEST ).
- Do the cruise control unit input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
Short to power in the LT GRN wire |
| Set speed does not cancel when the cancel switch is pressed (2004-05 models) |
- Check cruise control set/decel, resume/accel, cancel switch (see CRUISE CONTROL SET/DECEL, RESUME/ACCEL SWITCH TEST/REPLACEMENT ).
- Do the cruise control input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
Open circuit, loose or disconnected terminals: LT GRN/RED, LT GRN/BLK |
| Set speed will not resume when the resume/accel switch is pressed (with the cruise control main switch turned on, and set speed temporarily canceled by pressing the brake pedal) |
- Test the brake pedal position switch (see BRAKE PEDAL POSITION SWITCH TEST
) and check its adjustment.
- 2000-03 models: Check cruise control set/decel, resume/accel switch (see CRUISE CONTROL SET/DECEL, RESUME/ACCEL SWITCH TEST/REPLACEMENT ). 2004-05 models: Check cruise control set/decel, resume/accel, cancel switch (see CRUISE CONTROL SET/DECEL, RESUME/ACCEL SWITCH TEST/REPLACEMENT ).
- Do the cruise control unit input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
- Faulty brake pedal position switch
- Open circuit, loose or disconnected terminals: LT GRN/BLK
|
| Set speed will not resume when the resume/accel switch is pressed (with the cruise control main switch turned on, and set speed temporarily canceled by pressing the clutch pedal) |
- Test clutch pedal position switch (see CLUTCH PEDAL POSITION SWITCH TEST ) and check its adjustment (see CLUTCH PEDAL, CLUTCH PEDAL POSITION SWITCH, AND CLUTCH INTERLOCK SWITCH ADJUSTMENT
).
- 2000-03 models: Check cruise control set/decel, resume/accel switch (see CRUISE CONTROL SET/DECEL, RESUME/ACCEL SWITCH TEST/REPLACEMENT ). 2004-05 models: Check cruise control set/decel, resume/accel, cancel switch (see CRUISE CONTROL SET/DECEL, RESUME/ACCEL SWITCH TEST/REPLACEMENT ).
- Do the cruise control unit input test (see CRUISE CONTROL UNIT INPUT TEST ).
|
- Faulty clutch pedal position switch
- Open circuit, loose or disconnected terminals: LT GRN/BLK
|