DTC P0630: VIN Not Programmed or Mismatch (2004-2005 models)
NOTE:
- This DTC is stored only when the ECM does not have the VIN information of the vehicle. Use the HDS to fill the missing VIN information.
- Before you troubleshoot, record all freeze data and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
- Turn the ignition switch ON (II).
- Check the VIN with the HDS.
Does the HDS show the vehicle's VIN?
- YES - Go to step 5.
- NO - Go to step 3.
- Input the VIN to the ECM with the HDS.
Does the screen show COMPLETE?
- YES - Go to step 5.
- NO - Go to step 4.
- Check for DTCs with the HDS.
Is DTC P0607 indicated?
- YES - Go to the DTC P0607 troubleshooting.
- NO - Substitute a known-good ECM (see HOW TO SUBSTITUTE THE ECM FOR TESTING PURPOSES ), then recheck.
- Clear the DTC with the HDS.
- Turn the ignition switch OFF.
- Turn the ignition switch ON (II), and wait for 5 seconds.
- Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
- YES - If DTC P0630 is indicated, substitute a known-good ECM (see HOW TO SUBSTITUTE THE ECM FOR TESTING PURPOSES ), then recheck. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
- NO - Intermittent failure, system is OK at this time.