Low Fuel Indicator Test
WARNING: This page is about a different car, the 2009 Honda S2000, 2008 Honda S2000, 2007 Honda S2000, and 2006 Honda S2000. However, it is still accessible from the selected car via links, so may be relevant.
- Do the fuel gauge sending unit test (see FUEL GAUGE SENDING UNIT TEST
).
- If the system is OK, go to step 2.
- If the system has any malfunction, repair it.
- Turn the ignition switch OFF. Remove the No. 25 BACK UP (7.5 A) fuse from the under-dash fuse/relay box for at least 30 seconds, then reinstall it.
- Turn the ignition switch ON (II) with the float at the E (EMPTY) position.
- If the low fuel indicator is on, go to step 4.
- If the low fuel indicator is not on, refer to the low fuel indicator Circuit Diagram (see DTC TROUBLESHOOTING INDEX ), and check the circuit.
- Turn the ignition switch OFF. Remove the No. 25 BACK UP (7.5 A) fuse from the under-dash fuse/relay box for at least 30 seconds, then reinstall it.
- Lift the float above the LOW position.
- If the low fuel indicator goes off, the system is OK.
- If the low fuel indicator is still on, refer to the low fuel indicator Circuit Diagram (see DTC TROUBLESHOOTING INDEX ), and check the circuit.