Front Seat Cover Replacement: Notes

'00-02 models Sedan: SRS components are located in this area. Review the SRS components locations, precautions and procedures in AIR BAG RESTRAINT SYSTEMS article before performing repairs or service.

NOTE:

With side airbag ('00-02 models): The seat with a airbag is marked with a side airbag on the surface of the seat-back. Because the component parts (seat-back cover, cushion, etc.) of seats with and without airbags are different, make sure you install only the correct replacement parts.
'00-02 models Sedan: The front seats with side airbags are produced by three different suppliers. Before replacing the seat-back, make sure the seat-back cover (A), pad (B) and frame (C) are from the same supplier. Before assembling the seat-back, make sure the supplier's identification (D) is the same on each part.

Fig 1: Checking Supplier's Identification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
With side airbag ('00-02 models): Do not repair any tears or frayed spots of the seat-back cover. If necessary, replace the seat-back cover.
Take care not to tear the seams or damage the seat covers.
With side airbag ('00-02 models): Do not touch the Occupant Position Detection System OPDS sensor in the seat-back pad. Keep the sensor free from grease oils and moisture, as they can damage the sensor. Oils can corrode the sensor, causing its faulty.
Put on gloves to protect your hands.