DTC P1106: BARO Sensor Circuit Range/Performance Problem

Clear Diagnostic Trouble Codes. See CLEARING DIAGNOSTIC TROUBLE CODES  . Connect SCS Service Connector to 2-pin service check connector. See Figure . Start engine and run at 3000 RPM with no loads and transaxle in Park or Neutral until radiator fan comes on. Allow engine to idle. Test drive vehicle with transaxle in "2" position (4th gear on M/T). Accelerate for 5 seconds with Wide Open Throttle (WOT). If DTC P1106 is not indicated, problem is intermittent. System is okay at this time. If DTC P1106 is indicated, substitute a known good PCM and retest. See SUBSTITUTING POWERTRAIN CONTROL MODULE  . If symptom or indication goes away, replace original PCM. Perform final procedure. See FINAL PROCEDURE  .