Seat Belt System: Inspection: Retractor

'01-02 models: SRS components are located in this area. Review the SRS components locations, precautions and procedures in AIR BAG RESTRAINT SYSTEMS before performing repairs or service.

1. Before installing the retractor, check that the seat belt can be pulled out freely.
2. Make sure the seat belt does not lock when the retractor (A) is leaned slowly up to 15° from the mounted position. The seat belt should lock when the retractor is leaned over 40°. Do not attempt to disassemble the retractor.
   Fig 1: Ensuring Seat Belt Does Not Lock At 15 Degrees & Locks At 40 Degrees - Coupe

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
   Fig 2: Ensuring Seat Belt Does Not Lock At 15 Degrees & Locks At 40 Degrees - Sedan

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Replace the seat belt with a new one if there is any abnormality.