Master Switch Test

Remove the power window master switch (see MASTER SWITCH REPLACEMENT ).
Disconnect the 14P connector from the switch (A).

Fig 1: Disconnecting The 14P Connector From The Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.
Driver's Window Switch

The driver's switch is combined with the control unit so you cannot isolate the switch to test it.

Instead, run the master switch input test procedures (see MASTER SWITCH INPUT TEST ). If the tests are normal, the driver's switch must be faulty.

Passenger's Window Switch:

Fig 2: Passenger's Window Switch Test Table
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the switch is faulty, replace the switch.