Resetting the Power Window Control Unit

Resetting the power window control unit is required after performing the following procedures:

• Disconnecting the battery
• Removing the No. 6 (7.5A) and/or the No. 23 (20A) fuses from the under-dash fuse/relay box.
• Disconnecting the driver's door wire harness

1. Turn the ignition switch ON (II).
2. Move the driver's window all the way down by holding the driver's switch firmly down; when the window reaches the bottom, hold the driver's window switch firmly down for 2 seconds.
3. Move the driver's window all the way up by holding the driver's switch firmly up; when the window reaches the top, hold the driver's window switch firmly up for 2 seconds.
4. If the window does not work in AUTO, turn the ignition switch OFF and repeat steps 1 through 3.