Cruise Control Set/Resume/Cancel Switch Test/Replacement

Remove the two screws, then remove the switch.

Fig 1: Removing Two Screws & Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.
- If there is continuity, and it matches the table, but switch failure occurred on the cruise control unit input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or both positions, replace the switch.
  
  Fig 2: Checking For Continuity Between Terminals In Each Switch Position
  Courtesy of AMERICAN HONDA MOTOR CO., INC.