Transmission Range Switch Installation

Set the transmission to the N position by turning the control lever (A). Do not squeeze the end of the control shaft tips together when setting. If the tips are squeeze together it will cause a faulty signal or position due to the play between the control shaft and the switch.

Fig 1: Turning Control Lever
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Set the transmission range switch to the N position. The switch clicks in the N position.

Fig 2: Identifying Transmission Range Switch N Position
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the transmission range switch (A) gently on the selector control shaft (B), then tighten the bolts. Do not move the switch when tightening the bolts.

Fig 3: Identifying Tightening Torque Of Transmission Range Switch Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.