Scan Tool Testing and Procedures

How to End a Troubleshooting Session
This procedure must be done after any troubleshooting.
1. Turn the ignition switch OFF.





2. Reset the TCM. Use the OBD II Scan Tool or the Honda PGM Tester (A), then disconnect the scan tool or PGM tester from the DLC (B).
3. Turn the ignition switch ON (II).
4. Enter the radio code, reset the preset stations, and set the clock.
5. To verify that the problem is repaired, test-drive the vehicle for several minutes at speeds over 30 mph (50 km/h).