LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2003 >> Odyssey LX >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Keyless/Power Door Lock System >> Power Door Locks/Factory Keyless/Factory Security >> Keyless Receiver Unit Input Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Keyless Receiver Unit Input Test

  1. Remove the glove box (see GLOVE BOX REMOVAL/INSTALLATION ).
  2. Disconnect the 14P connector (A) from the keyless receiver unit (B).
    Fig 1: Disconnecting 14P Connector From Keyless Receiver Unit
    G01520275Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Inspect the all connector and socket terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals look OK, go to step 4.
  4. Make these input tests at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, go to step 5.
    Fig 2: Keyless Receiver Unit Input Test (Keyless Receiver Unit Disconnected)
    G01520276Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Reconnect the connector to the control unit, and perform the following input tests at the keyless receiver unit connector.
    • If any test indicates a problem, find and correct the cause then recheck the system.
    • If all the input tests prove OK, the keyless receiver unit must be faulty; replace it.
Fig 3: Keyless Receiver Unit Input Test (Keyless Receiver Unit Connected)
G01520277Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals