Engine Lubrication System

Engine Lubrication Specification Table

Item	Measurement	Qualification	Standard or New	Service Limit
Engine oil	Capacity	Engine overhaul	5.3 l (5.6 US qt)
		Oil change, including filter	4.2 l (4.4 US qt)
		Oil change, without filter	4.0 l (4.2 US qt)
Oil pump	Inner-to-outer rotor clearance		0.02-0.16 mm (0.001-0.006 in.)	0.20 mm (0.008 in.)
	Pump housing-to-outer rotor clearance		0.15-0.21 mm (0.006-0.008 in.)	0.23 mm (0.009 in.)
	Pump housing-to-rotor axial clearance	2002-2003 models	0.020-0.070 mm (0.0008-0.0027 in.)	0.12 mm (0.005 in.)
	Pump housing-to-rotor axial clearance	2004 model	0.035-0.070 mm (0.0014-0.0027 in.)	0.12 mm (0.005 in.)
	Balancer shafts, journal diameter	No. 1 journal, front shaft	19.938-19.950 mm (0.7850-0.7854 in.)	19.92 mm (0.784 in.)
		No. 1 journal, rear shaft	23.938-23.950 mm (0.9424-0.9429 in.)	23.92 mm (0.942 in.)
		No. 2 journal, front and rear shaft	32.949-32.961 mm (1.2972-1.2977 in.)	32.93 mm (1.296 in.)
	Balancer shafts, journal taper		0.005 mm (0.0002 in.) max.	-
	Balancer shafts, end play	Front	0.070-0.135 mm (0.0028-0.0053 in.)	0.15 mm (0.006 in.)
	Balancer shafts, end play	Rear	0.070-0.135 mm (0.0028-0.0053 in.)	0.15 mm (0.006 in.)
	Balancer shafts, shaft-to-bearing clearance	No. 1 journal, front shaft	0.050-0.082 mm (0.0020-0.0032 in.)	0.10 mm (0.004 in.)
		No. 1 journal, rear shaft	0.050-0.082 mm (0.0020-0.0032 in.)	0.10 mm (0.004 in.)
		No. 2 journal, front and rear shaft	0.060-0.120 mm (0.0024-0.0047 in.)	0.15 mm (0.006 in.)
	Balancer shaft bearings, I.D.	No. 1 journal, front shaft	20.000-20.020 mm (0.7874 0.7882 in.)	20.03 mm (0.789 in.)
		No. 1 journal, rear shaft	24.000-24.020 mm (0.9449-0.9457 in.)	24.03 mm (0.946 in.)
		No. 2 journal, front and rear shaft	33.021-33.069 mm (1.3000-1.3019 in.)	33.09 mm (1.303 in.)
	Relief valve, oil pressure with oil temperature at 176°F (80°C)	At idle	70 kPa (0.7 kgf/cm² , 10 psi) min.
		At 3, 000 rpm	300 kPa (3.1 kgf/cm² , 44 psi) min.