Steering Service Specifications: Steering
Steering Specifications Table
| Item | Measurement | Qualification | Standard or New | Service Limit |
|---|---|---|---|---|
| Steering wheel | Rotational play measured at outside edge | With engine running | 0-10 mm (0-0.39 in.) | - |
| Starting load measured at outside edge | With engine running | 30 N (3.1 kgf, 6.8 lbf) | - | |
| Gearbox | Angle of rack guide screw loosened from locked position | 20° Max | ||
| Pump | Output pressure with shut-off valve closed | 8, 300-8, 800 kPa (85-90 kgf/cm2 , 1, 210 - 1, 280 psi) | ||
| Power steering fluid | Capacity | For fluid change | 0.4 l (0.42 US qt) | |
| Use Honda Power Steering Fluid | For system overhaul | 1.1 l (1.16 US qt) | ||
| Power steering pump belt
NOTE:
Adjust a new
belt to the new belt spec, run the engine for 5 minutes, then readjust it to the used
belt spec.
|
Deflection with 98 N (10 kgf, 22 lbf) applied mid-way between pulleys | Used belt: 13.0-16.5 mm (0.51-0.65 in. | ||
| New belt: 8.5-11.0 mm (0.33-0.43 in.) | ||||
| Tension (measured with belt tension gauge) | Used belt: 390-540 N (40-55 kgf, 88-120 lbf) | |||
| New belt: 740-880 N (75-90 kgf, 170-200 lbf) | ||||