LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2004 >> Pilot LX >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostics >> Erasing Diagnostic Trouble Code Memory >> Erasing DTC Memory Using SCS Service Connector
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Erasing DTC Memory Using SCS Service Connector

  1. Turn ignition switch to OFF position. Connect SCS Service Connector (07PAZ-0010100) to Memory Erase Signal (MES) connector. See Fig 1 .
  2. Turn ignition switch to ON position. AIR BAG warning light will come on for about 6 seconds then go off.
  3. Disconnect SCS service connector from MES connector within 4 seconds after AIR BAG warning light goes off. AIR BAG warning light will come on again.
  4. Reconnect SCS service connector to MES connector within 4 seconds after AIR BAG warning light comes on. AIR BAG warning light will go off.
  5. Disconnect SCS service connector from MES connector within 4 seconds. AIR BAG warning light will indicate that memory is erased by blinking 2 times. Turn ignition switch to OFF position and wait 10 seconds. DTC's are erased if AIR BAG warning light comes on for 6 seconds and then goes out.
Fig 1: Locating Memory Erase Signal (MES) Connector
G99D30208Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals