35 mm Thrust Shim Selection: Notes
- Select the 35 mm thrust shim if the transfer driven gear shaft or the tapered roller bearing on the transfer driven gear shaft is replaced.
Calculate the thickness of the 35 mm thrust shim using the formula below.
FORMULA: A/100-B/100+c=X
A: Number on the existing transfer driven gear shaft.
B: Number on the replacement transfer driven gear shaft.
C: Thickness of the existing 35 mm thrust shim.
X: Thickness needed for the replacement 35 mm thrust shim.
NOTE: The number on the transfer driven gear shaft is shown in 1/100 mm.
EXAMPLE:
X=A/100-B/100+C= 2/100-1/100+1.05
=0.02+0.01+1.05=1.08(mm)
Select 35 mm thrust shim thickness of 1.08 mm (0.043 in.).
NOTE:
- If the tapered roller bearing on the transfer driven gear shaft is replaced.
- Measure the thickness of the replacement bearing and the existing bearing, and calculate the difference of the bearing thickness.
- Adjust the thickness of the existing 35 mm thrust shim by the amount of difference in bearing thickness, and select the replacement 35 mm thrust shim.
- Do not use more than one 35 mm thrust shim to adjust the transfer gear backlash.
THRUST SHIM, 35 mm
THRUST SHIM THICKNESS SPECIFICATIONS (35 MM)
| Shim No. | Part Number | Thickness |
|---|---|---|
| A | 41361-PS3-000 | 0.72 mm (0.028 in.) |
| B | 41362-PS3-000 | 0.75 mm (0.030 in.) |
| C | 41363-PS3-000 | 0.78 mm (0.031 in.) |
| D | 41364-PS3-000 | 0.81 mm (0.032 in.) |
| E | 41365-PS3-000 | 0.84 mm (0.033 in.) |
| F | 41366-PS3-000 | 0.87 mm (0.034 in.) |
| G | 41367-PS3-000 | 0.90 mm (0.035 in.) |
| H | 41368-PS3-000 | 0.93 mm (0.037 in.) |
| I | 41369-PS3-000 | 0.96 mm (0.038 in.) |
| J | 41370-PS3-000 | 0.99 mm (0.039 in.) |
| K | 41371-PS3-000 | 1.02 mm (0.040 in.) |
| L | 41372-PS3-000 | 1.05 mm (0.041 in.) |
| M | 41373-PS3-000 | 1.08 mm (0.043 in.) |
| N | 41374-PS3-000 | 1.11 mm (0.044 in.) |