Cruise Control Main Switch Test/Replacement

Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ).
Release the clips of the cruise control main switch, and push the switch (A) out of the panel, then disconnect the 13P connector (B) from the switch.

Fig 1: Disconnecting 13P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table. If the continuity is not as specified, replace illumination bulbs (A) or the switch.

Fig 2: Replacing Illumination Bulbs Or Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 3: Terminals Switch Position Specification Table
Courtesy of AMERICAN HONDA MOTOR CO., INC.