LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2005 >> Element 2WD L4-2.4L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair >> Side Impact Sensor Replacement
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Side Impact Sensor Replacement

Side Impact Sensor Replacement

Removal

1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the appropriate side airbag 2P connector.
3. Remove the seat assembly.
4. Remove the door sill trim.
5. Disconnect the floor wire harness 2P connector from the side impact sensor.




6. Using a Torx T30 bit, remove the Torx bolt (A), then remove the side impact sensor (B).

Installation




1. Install the new side impact sensor with the Torx bolt (A), then connect the floor wire harness 2P connector (B) to the side impact sensor.
2. Reconnect the battery negative cable
3. After installing the side impact sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
4. Install all removed parts.
scientia non olet · About LEMON Manuals