LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2006 >> CR-V SE >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Windows >> Driver's Window Motor Test >> Pulser Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pulser Test

  1. Reconnect the 6P connector to the window motor, and reconnect the 20P connector to the power window master switch.
  2. Check for voltage between the terminals.
    • There should be battery voltage between the No. 6 (+) and No. 4 (-) terminals when the ignition switch is turned ON (II).
    • Connect an analog voltmeter between the No. 5 (+) and No. 4 (-) terminals, and run the window motor down or up. The voltmeter needle should move back and forth alternately between 0 V and about 5 V (a digital voltmeter should show about 2.5 V).
    • Connect an analog voltmeter between the No. 3 (+) and No. 4 (-) terminals, and run the window motor down or up. The voltmeter needle should move back and forth alternately between 0 V and about 5 V (a digital voltmeter should show about 2.5 V).
  3. If the voltage is not as specified, replace the driver's power window motor.
scientia non olet · About LEMON Manuals