LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2006 >> Civic GX >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Fuel System & Emissions System (R18A1 Engine) >> System Description >> ECM/PCM Inputs and Outputs at ECM/PCM Connector C (◦) (44P) >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ECM/PCM Inputs and Outputs at ECM/PCM Connector C (◦) (44P): Notes

Fig 1: Identifying ECM/PCM Inputs And Outputs For ECM/PCM Connector C (◦) (44P)
G06772384Courtesy of AMERICAN HONDA MOTOR CO., INC.
CONNECTOR TERMINALS DESCRIPTION CHART

Terminal number Wire color Terminal name Description Signal
1 WHT/GRN IG1 ETCS (IGNITION SIGNAL ETCS) Detects ignition signal With ignition switch ON (II): battery voltage
2 BLK PGMETCS (POWER GROUND ETCS) Ground circuit for ECM/PCM Less than 0.2 V at all times
3 YEL/GRN ETCSM- (THROTTLE ACTUATOR -SIDE) Ground for throttle actuator With ignition switch ON (II): about 0 V
4 YEL/RED ETCSM+ (THROTTLE ACTUATOR +SIDE) Drives throttle actuator With ignition switch ON (II): about 0 V
5 BRN INJ1 (No. 1 INJECTOR) Drives No. 1 injector At idle: duty controlled
With ignition switch ON (II): battery voltage
6 RED INJ2 (No. 2 INJECTOR) Drives No. 2 injector  
7 BLU INJ3 (No. 3 INJECTOR) Drives No. 3 injector  
8 YEL INJ4 (No. 4 INJECTOR) Drives No. 4 injector  
9 GRN AFSHTC (AIR FUEL RATIO (A/F) SENSOR (SENSOR 1) HEATER CONTROL) Drives A/F sensor (sensor 1) heater With ignition switch ON (II): battery voltage
With warmed up engine running: about 0 V
11 GRN/RED MAP (MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR) Detects MAP sensor signal With ignition switch ON (II): about 3.0 V
At idle: about 1.0 V (depending on engine speed)
12 GRN VCC3 (SENSOR VOLTAGE) Provides sensor reference voltage With ignition switch ON (II): about 5.0 V
13 YEL/RED VCC1 (SENSOR VOLTAGE) Provides sensor reference voltage With ignition switch ON (II): about 5.0 V
14 GRN/WHT SG1 (SENSOR GROUND) Sensor ground Less than 0.2 V at all times
15 YEL/GRN IGPLS1 (No. 1 IGNITION COIL PULSE) Drives No. 1 ignition coil With ignition switch ON (II): about 0 V
With engine running: pulses
16 BLU/RED IGPLS2 (No. 2 IGNITION COIL PULSE) Drives No. 2 ignition coil
17 WHT/BLU IGPLS3 (No. 3 IGNITION COIL PULSE) Drives No. 3 ignition coil
18 BRN IGPLS4 (No. 4 IGNITION COIL PULSE) Drives No. 4 ignition coil
20 RED/BLK TPSA (THROTTLE POSITION (TP) SENSOR A) Detects TP sensor A signal With throttle fully open: about 3.9 V
With throttle fully closed: about 0.9 V
21 YEL TPSB (THROTTLE POSITION (TP) SENSOR B) Detects TP sensor B signal With throttle fully open: about 4.1 V
With throttle fully closed: about 1.7 V
22 WHT/BLK POIL (ROCKER ARM OIL PRESSURE SENSOR (ENGINE OIL PRESSURE (EOP) SENSOR)) Detects rocker arm oil pressure sensor (EOP sensor) signal With ignition switch ON (II): about 0.5 V
With engine running: about 0.7 V (depending on engine oil pressure)
27 WHT/RED SHO2S (SECONDARY HEATED OXYGEN SENSOR (SECONDARY HO2S) (SENSOR 2)) Detects secondary HO2S (sensor 2) signal With throttle fully opened from idle with warmed up engine: about 0.6 V
With throttle quickly closed: below 0.4 V
29 RED AFS+ (AIR FUEL RATIO (A/F) SENSOR (SENSOR 1) +SIDE) Detects A/F sensor (sensor 1) signal  
30 RED/YEL AFS- (AIR FUEL RATIO (A/F) SENSOR (SENSOR 1) -SIDE) Detects A/F sensor (sensor 1) signal  
31 WHT/GRN CMP (CAMSHAFT POSITION (CMP) SENSOR) Detects CMP sensor signal With engine running: pulses
32 BLU/WHT CKP (CRANKSHAFT POSITION (CKP) SENSOR) Detects CKP sensor signal With engine running: pulses
36 BLK/YEL IG1 (IGNITION SIGNAL) Detects ignition signal With ignition switch ON (II): battery voltage
39 BLU SG3 (SENSOR GROUND) Sensor ground Less than 0.2 V at all times
40 BRN/YEL LG1 (LOGIC GROUND) Ground circuit for ECM/PCM Less than 0.2 V at all times
42 RED/BLU KS(KNOCK SENSOR) Detects knock sensor signal With engine knocking: pulses
43 BLK/BLU NC (OUTPUT SHAFT (COUNTERSHAFT) SPEED SENSOR) Detects output shaft (countershaft) speed sensor signals With ignition switch ON (II): about 0 V or about 5.0 V
With vehicle moving: about 2.5 V (pulses)
44 BRN/YEL LG2 (LOGIC GROUND) Ground circuit for ECM/PCM Less than 0.2 V at all times