DTC P0603: ECM/PCM Internal Control Module Keep Alive Memory (KAM) Error ('06-08 models); DTC P062F: ECM/PCM Internal Control Module Keep Alive Memory (KAM) Error ('09-11 models)
NOTE:
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
- Information marked with an asterisk (*) applies to the '06-08 models.
- Information marked with a double asterisk (* *) applies to the '09-11 models.
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS.
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0603* (P062F)* * indicated?
YES -Go to step 4.
NO -Intermittent failure, the system is OK at this time.
- Update the ECM/PCM if it does not have the latest software (see ECM/PCM UPDATE ), or substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ).
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0603* (P062F)** indicated?
YES -If the ECM/PCM was updated, substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ), then recheck. If the ECM/PCM was substituted, go to step 1.
NO -If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM (see ECM/PCM REPLACEMENT ). If any other Pending or Confirmed DTCs are indicated, go to the INDICATED DTC'S TROUBLESHOOTING .