DTC P0717: Problem in CVT Input Shaft (Drive Pulley) Speed Sensor Circuit (No Signal Input): General Description
The CVT input shaft (drive pulley) speed sensor detects the number of revolutions of the gear on the drive pulley and sends a pulsing signal to the transmission control module (TCM).
When the shift lever is in D, L, or R, and the engine speed is at a specified value or more while there is no input signal from the CVT input shaft (drive pulley) speed sensor, a malfunction is detected and a DTC is stored.
MONITOR DESCRIPTION CHART
| Execution | Continuous |
| Sequence | None |
| Duration | 15 seconds or more |
| DTC Type | One drive cycle, MIL ON, D indicator blinks |
ENABLE CONDITIONS CHART
| Condition | Minimum | Maximum |
|---|---|---|
| Engine speed | 576 rpm | - |
| Driven pulley speed | 128 rpm | - |
| Shift lever position | D, L, or R | |
| No active DTCs | Transmission range switch, CVT output shaft (driven pulley) speed sensor, Engine RPM signal input circuit | |