DTC B1063: Relay Control Module Lost Communication with Combination Switch Control Unit (Wiper switch message)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch OFF, and then back ON (II).
- Wait for 6 seconds or more.
- Check for DTCs with the HDS.
Is DTC B1063 indicated?
- YES - Go to step 5.
- NO - Intermittent failure, the communication line is OK at this time.
- Check for DTCs with the HDS.
Are DTCs B1156, and B1958 also indicated?
- YES - Go to combination switch control unit input test (see COMBINATION SWITCH CONTROL UNIT INPUT TEST ).
- NO - Go to relay control module input test (see RELAY CONTROL MODULE INPUT TEST ).