Ignition Switch: Service and Repair

Replacement

SRS components are located in this area. Review the SRS component locations and precautions and procedures before performing repairs or servicing.

1. Make sure you have anti-theft codes for the audio and navigation system. If equipped with XM radio, write down the XM radio presets.
2. Turn the ignition switch OFF, and disconnect the negative battery cable.
3. Remove the driver's dashboard lower cover and the steering column covers.




4. Disconnect the 7P connector (A) from the ignition switch (B).
5. Remove the two screws and the ignition switch.
6. Install the ignition switch in the reverse order of removal.
7. After reconnecting the battery, enter the audio and navigation system anti-theft codes, and set the clock. If equipped with XM radio, enter the XM radio presets.