LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2007 >> Element SC, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Navigation System >> Symptom Troubleshooting >> Voice control does not work/respond >> Diagnostic Test: Mic Level
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test: Mic Level

NOTE:
  • Check the vehicle battery condition first (see BATTERY TEST ).
  • Make sure that the correct DVD color and version are installed.
  • Check any official Honda service website for more service information about the navigation system.
  • Check the connector for poor connection or loose terminals.
  • Before troubleshooting, make sure you have the navigation system anti-theft code.
  • After troubleshooting, enter the navigation system anti-theft code.

Before assuming that a voice complaint is hardware related, ensure that the voice control system is being operated correctly.

  1. Turn the ignition switch to ON (II).
  2. Go into the SYSTEM DIAGNOSTIC MODE , select Mic Icon Menu, and use the Mic Level test under Functional Setup to check the operation of the navigation TALK and navigation BACK buttons.

    Are the navigation TALK and navigation BACK buttons operational when you press the buttons? 

    YES  -Go to step  10.

    NO  -Go to step 3.

  3. Turn the ignition switch to LOCK (0).
  4. Do the VOICE CONTROL SWITCH TEST  .

    Is the voice control switch OK? 

    YES  -Go to step 5.

    NO  -Replace the AUDIO REMOTE SWITCH TEST/REPLACEMENT . ■

  5. Disconnect the audio remote-navigation voice control switch 5P connector and audio-navigation unit connector F(12P).
  6. Check for continuity between body ground and audio-navigation unit connector F (12P) terminal No. 1.
    Fig 1: Checking For Continuity Between Body Ground And Audio-Navigation Unit Connector F (12P) Terminal No. 1
    G08049679Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Repair a short to body ground in the wire between audio-navigation unit and voice control switch, or replace the cable reel . ■

    NO  -Go to step 7.

  7. Check for continuity between audio-navigation unit connector F (12P) terminal No. 1 and audio remote-navigation voice control switch 5P connector terminal No. 5.
    Fig 2: Checking For Continuity Between Audio-Navigation Unit Connector F (12P) Terminal No. 1 And Audio Remote-Navigation Voice Control Switch 5P Connector Terminal No. 5
    G08049680Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Go to step 8.

    NO  -Replace the AUDIO-NAVIGATION UNIT  . ■

  8. Disconnect audio-navigation unit connector A (24P).
  9. Check for continuity between audio-navigation unit connector A (24P) terminal No. 5 and the audio remote-navigation voice control switch 5P connector terminal No. 1.
    Fig 3: Checking For Continuity Between Audio-Navigation Unit Connector A (24P) Terminal No. 5 And Audio Remote-Navigation Voice Control Switch 5P Connector Terminal No. 1
    G08049681Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Replace the AUDIO-NAVIGATION UNIT  . ■

    NO  -Repair an open in the wire between the audio-navigation unit and voice control switch, or replace the cable reel . ■

  10. Use the MIC LEVEL  diagnosis under Functional Setup to check the operation of the microphone.

    Is the microphone operational? 

    YES  -Check the operation of the voice control system (see the Navigation System Manual). ■

    NO  -Go to DTC 2707: MIC DIAG  . ■