LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2007 >> Element SC, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Fuel And Emissions Systems >> How to Set Readiness Codes >> Air Fuel Ratio (A/F) Sensor Monitor and Readiness Code >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Air Fuel Ratio (A/F) Sensor Monitor and Readiness Code: Procedure

  1. Start the engine.
  2. Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise. During the drive, decelerate (with the throttle fully closed) for 5 seconds. After about 3.5 miles (5.6 km), the readiness code should switch from incomplete to complete.
  3. Check the readiness codes screen for the AIR FUEL RATIO (A/F) SENSOR in the DTCs MENU with the HDS.
    • If the screen shows complete, readiness is complete.
    • If the screen shows not complete, go to the next step.
  4. Check for a Temporary DTC. If there is no DTC, the enable criteria was probably not met. Select the DATA LIST MENU. Check the ECT in the ALL DATA LIST with the HDS. If the ECT is less than 140°F (60°C), run the engine until it is more than 140°F (60°C), then repeat the procedure.
scientia non olet · About LEMON Manuals