DTC 1701: R- Camera Error; DTC 2608: R- Camera Diag
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Honda Crosstour, 2014 Honda Crosstour, 2013 Honda Crosstour, 2012 Honda Crosstour, and 2011 Honda Accord Crosstour. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Check the vehicle battery condition first (see BATTERY TEST ).
- These navigation DTC set when a communication error between the rearview camera and the navigation display (open or short) is detected.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION ).
- Turn the ignition switch to LOCK (0), then back to ON (II).
- Go into the System Diagnostic Mode, and select the Self-Diagnosis Mode in the Select Diagnosis Items menu (see SYSTEM LINKS ).
- Check the System Links.
Is the R- camera icon red?
YES -Go to next step.
NO -Intermittent failure, the system is OK at this time.
- Check for poor connection or loose terminal at the rearview camera 6P connector.
Are the connections OK?
YES -Go to next step.
NO -Repair poor connection or loose terminals, and recheck.
- Turn the ignition switch to LOCK (0).
- Disconnect the rearview camera 6P connector.
- Turn the ignition switch to ON (II).
- Measure the voltage between rearview camera 6P connector terminal No. 6 and body ground.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there about 3.0 V?
YES -Replace the rearview camera (see REARVIEW CAMERA REMOVAL/INSTALLATION ).
NO -Go to next step.
- Measure the voltage between navigation display unit 28P connector terminal No. 15 and body ground.Fig 2: Measuring Voltage Between Navigation Display Unit 28P Connector Terminal No. 15 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there about 3.0 V?
YES -Repair an open in the wire between the navigation display unit and the rearview camera.
NO -Replace the navigation display unit (see NAVIGATION DISPLAY UNIT REMOVAL/INSTALLATION ).