VSA Modulator-Control Unit Inputs and Outputs for 22P Connector (Connector Disconnected)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Honda Crosstour, 2014 Honda Crosstour, 2013 Honda Crosstour, 2012 Honda Crosstour, and 2011 Honda Accord Crosstour. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying VSA Modulator-Control Unit 22P Connector Terminal Location

Courtesy of AMERICAN HONDA MOTOR CO., INC.

TERMINAL DESCRIPTION

Terminal number	Wire color	Terminal sign	Description	Signal
1	BLK	GND	Ground for the VSA modulator-control unit	Continuity to ground
2	BLK	M-GND	Ground for the pump motor	Continuity to ground
3	WHT	FSR + B	Power source for the fail-safe relay	Battery voltage (about 12 V) at all times
4	RED	MR + B	Power source for the motor relay	Battery voltage (about 12 V) at all times
5	RED	WEN	Detects write enable signal	--
6	BLU	STR-Z	Detects steering angle sensor signal
7	LT GRN	STR-B	Detects steering angle sensor signal
8	GRY	IG1	Power source for activating the system	With ignition switch ON (II): battery voltage (about 12 V)
9	BRN	SGND	Ground for the steering angle sensor	--
10	WHT	F-CAN H	F-CAN communication circuit
11	PNK	RRR +	Detects right-rear wheel speed sensor signal
12	ORN	FRL +	Detects left-front wheel speed sensor signal
13	BLU	RRL +	Detects left-rear wheel speed sensor signal
14	LT GRN	FRR+	Detects right-front wheel speed sensor signal	--
15	RED	F-CAN L	F-CAN communication circuit	--
16	LT BLU	K-LINE	Communication with HDS	Pulse voltage (digital signal)
17	PUR	RRR-	Detects right-rear wheel speed sensor signal	--
18	GRN	FRL-	Detects left-front wheel speed sensor signal
19	RED	RRL-	Detects left-rear wheel speed sensor signal
20	ORN	SVCC	Power source for the steering angle sensor
21	PUR	FRR-	Detects right-front wheel speed sensor signal
22	GRN	STR-A	Detects steering angle sensor signal