Special Tools Required
- Holder handle 07JAB-001020B
- Oil seal driver attachment 07JAD-PH80101
- Companion flange holder 07RAB-TB4010A or 07RAB-TB4010B
- Attachment, 72 x 75 mm 07746-0010600
- Driver handle 07746-0030100
- Attachment, 35 mm I.D. 07746-0030400
- Driver 07749-0010000
NOTE:
- While reassembling the transfer assembly:
- Check and adjust the transfer gear tooth contact.
- Measure and adjust the transfer gear backlash.
- Check and adjust the tapered roller bearing starting torque.
- Coat all parts with manual transmission fluid (MTF) during reassembly.
- Replace the tapered roller bearing and the tapered roller bearing outer race as a set if either part is replaced.
- Replace the transfer drive gear and the transfer output shaft as a set if either part is replaced.