Cruise Control Combination Switch Test/Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before performing repairs or service.

1. Remove the driver's airbag (see DRIVER'S AIRBAG REPLACEMENT ).
2. Remove the three screws, then disconnect the connector (A), and remove the cruise control combination switch (B).
   Fig 1: Identifying Connector And Cruise Control Combination Switch

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Check for continuity between the terminals in each switch position according to the table.
   • If there is continuity, and it matches the table, but switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or both positions, replace the switch.
   Fig 2: Identifying Cruise Control Combination Switch Connector Terminals With Continuity Chart
   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Check for continuity between the terminals in according to Fig 3.
   • If there is continuity, and it matches the table, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or more positions, replace the switch.
   Fig 3: Checking For Continuity Between Terminals Chart
   Courtesy of AMERICAN HONDA MOTOR CO., INC.