October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Fuel Tank Unit Removal and Installation: Installation
- Temporarily attach a new base gasket (A) to the fuel tank unit (B), then insert the fuel tank unit partially into the fuel tank.
NOTE:
- Be careful not to damage the new base gasket.
- Be careful not to bend the fuel gauge sending unit.
- Do not coat the base gasket with oil.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Transfer the base gasket (A) from the fuel tank unit to the fuel tank.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Align the marks (B) on the fuel tank and the fuel tank unit, then insert the fuel tank unit until it sits on the base gasket.
NOTE:
To prevent a fuel leak, check the base gasket, visually or by hand, to make sure it is not pinched.
- Using the tool, tighten the new locknut (A) to the specified torque.
NOTE:
- After tightening, make sure the marks are still aligned.
- After installation, check the base gasket visually or by hand to be sure it is not pinched.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Connect the fuel tank unit 4P connector.
- Reconnect the quick-connect fitting to the fuel tank unit.
- Reconnect the negative cable to the battery, and turn the ignition switch ON (II) (but do not operate the starter motor). The fuel pump will run for about 2 seconds, and fuel pressure will rise. Repeat two or three times, and check that there is no leakage in the fuel supply system.
- Install the access panel on the floor.
- Install the center console (see
CENTER CONSOLE REMOVAL/INSTALLATION
).