Steering Angle Sensor Communication Stop Mode: Description
WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
TROUBLESHOOTING TABLE
| Detection Item |
Symptom |
Trouble Area |
| STEERING ANGLE SENSOR COMMUNICATION STOP MODE |
- "STEERING SENSOR" is not displayed on the "Bus Check "screen of the intelligent tester via the CAN VIM.
- DTCs are output from each ECU in steering angle sensor communication stop mode as shown in the "DTC COMBINATION TABLE" (See DTC COMBINATION PROBLEM SYMPTOMS TABLE
).
|
- Power source or inside the steering angle sensor
- Steering angle sensor sub bus line or connector
|