Wheel Speed Sensor Replacement: Front
- Make sure the ignition switch is OFF.
- Release the connector holding clamps (A), then disconnect the wheel speed sensor connector (B).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Remove the clips, the bolt, and the wheel speed sensor (C).
- Install the wheel speed sensor in the reverse order of removal, and note these items:
- Install the sensor carefully to avoid twisting the wires.
- If the wheel speed sensor comes in contact with the wheel bearing, it is faulty.
- Start the engine, and check that the ABS indicator goes off.
- Test-drive the vehicle, and check that the ABS indicator does not come on.