Data List/Active Test
WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
- READ DATA LIST
- While the intelligent tester is connected to the DLC3 with the ignition switch in the ON position, the CRUISE CONTROL data list can be displayed. Follow the prompts on the tester screen to access the data list.
ECM (Cruise control):
ITEM NORMAL CONDITION TABLEItem Measurement Item / Display (Range) Normal Condition Diagnostic Note VEHICLE SPD Vehicle speed / min.: 0 mph (0 km/h), max.: 158 mph (255 km/h) Actual vehicle speed - MEMORY SPD Cruise control memorized speed / min.: 22.5 mph (36 km/h), max.: 125 mph (200 km/h) Actual stored vehicle speed - CRUISE CONTROL Cruise control system active condition / ON or OFF ON: Cruise control activated
OFF: Cruise control inactivated- MAIN SW (MAIN) Main switch signal (Main CPU) / ON or OFF ON: Main switch ON (Pushed on)
OFF: Main switch OFF (Pushed off)"3" MAIN SW (SUB) Main switch signal (Sub CPU) / ON or OFF ON: Main switch ON (Pushed on)
OFF: Main switch OFF (Pushed off)"3" CCS READY M Cruise control system standby condition (Main CPU) / ON or OFF ON/OFF: Change ON/OFF each main switch is pushed in "1" CCS READY S Cruise control system standby condition (Sub CPU) / ON or OFF ON/OFF: Change ON/OFF each main switch is pushed in "1" CCS INDICATOR M Cruise indicator signal (Main CPU) / ON or OFF ON: "CCS READY" ON
OFF: "CCS READY" OFF"2" CANCEL SW CANCEL switch signal / ON or OFF ON: CANCEL switch ON
OFF: CANCEL switch OFF- -/SET SW -/SET switch signal / ON or OFF ON: SET / COAST switch ON
OFF: SET / COAST switch OFF- +/SET SW +/SET switch signal / ON or OFF ON: RES / ACC switch ON
OFF: RES / ACC switch OFF- STP LIGHT SW M Stop light switch signal (Main CPU) / ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released- STP LIGHT SW S2 Stop light switch-2 signal (Sub CPU) / ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released- STP LIGHT SW S1 Stop light switch-1 signal (Sub CPU) / ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released- SHIFT D POS PNP switch signal (D position) / ON or OFF ON: Shift lever on D
OFF: Shift lever not on D- HINT:
- "3" is OK but "1" is NG --> ECM failure
- "1" is OK but "2" is NG --> DTC output or ECM failure
- "3" is OK but CRUISE indicator does not come on --> CRUISE main indicator, wire harness or ECM failure