Yaw Rate Sensor Communication Stop Mode: Description
WARNING: This page is about a different car, the 2007 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
TROUBLESHOOTING TABLE
| Detection Item |
Symptom |
Trouble Area |
| YAW RATE SENSOR COMMUNICATION STOP MODE |
- YAW/DECELERAT is not displayed on the" BUS CHECK" screen of the intelligent tester via the CAN VIM
- "CHECK" screen of the intelligent tester via the CAN VIM. DTCs are output from each ECU in yaw rate sensor communication stop mode as shown in the "DTC COMBINATION TABLE" (See DTC COMBINATION PROBLEM SYMPTOMS TABLE
).
|
- Power source or inside the yaw rate sensor
- Yaw rate sensor sub bus line or connector
|