DTC 41: Abnormal Signal Reception Error
WARNING: This page is about a different car, the 2008 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Inspect for an aftermarket device interfering with the RF signal from the sensors when driving the vehicle.
- Turn the ignition switch OFF.
- Make sure all four wheels are TPMS wheels with tire pressure sensors.
Are TPMS type wheels with tire pressure sensors mounted on the vehicle?
YES - Go to step 5.
NO - Go to step 3.
- Install known-good TPMS wheels.
- Memorize the tire pressure sensor ID with the HDS (see MEMORIZING THE TIRE PRESSURE SENSOR ID ).
- Turn the ignition switch ON (II).
- Do the tire pressure sensor ID memorization (see
MEMORIZING THE TIRE PRESSURE SENSOR ID ).
Did each tire sensor location respond to the TPMS initializer tool?
YES - Replace the appropriate tire pressure sensor (see TIRE PRESSURE SENSOR REPLACEMENT ).
NO - Go to step 7.
- Substitute a known-good TPMS control unit (see
TPMS CONTROL UNIT REPLACEMENT ) and memorize the tire pressure sensor IDs (see
MEMORIZING THE TIRE PRESSURE SENSOR ID ).
Did all sensor IDs register to the TPMS control unit?
YES - Replace the original TPMS control unit.
NO - Replace the appropriate tire pressure sensor that did not register to the TPMS control unit.