LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2007 >> Odyssey EX-L >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Multiplex Integrated Control System >> Gauge Control Module Input Test
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Gauge Control Module Input Test

  1. Remove the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).
  2. Disconnect connector A (30P) from the gauge control module.
  3. Inspect the connector and socket terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals look OK, go to step 4.
      Fig 1: Identifying Gauge Control Module 30P Connector
      G05526545Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Reconnect connector A to the gauge control module, and make these input tests at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, replace the gauge control module.
    WIRE AND TEST CONDITION CHART

    Cavity Wire Test Condition Test: Desired result Possible cause if desired result is not obtained
    A6 WHT/RED Under all conditions Measure the voltage to ground:
    There should be battery voltage.
    • Blown No. 7 (7.5 A) fuse in the driver's under-dash fuse/relay box
    • An open in the wire
    A5 YEL Ignition Switch ON (II) Measure the voltage to ground:
    There should be battery voltage.
    • Blown No. 21 (7.5 A) fuse in the driver's under-dash fuse/relay box
    • An open in the wire
    A20 BLK Under all conditions Measure the voltage to ground:
    There should be less than 0.5 V.
    • Poor ground (G502)
    • An open in the wire
    A21
    A25 BRN/YEL Disconnect driver's under-dash fuse/relay box N (45P) and gauge control module A (30P) connectors Check for continuity between the A25 terminal and the driver's under-dash fuse/relay box connector N (45P) No. 28 terminal:
    There should be continuity.    		 An open in the wire
    Check for continuity between the A25 terminal and body ground:
    There should be no continuity.    		 A short to ground in the wire
scientia non olet · About LEMON Manuals