Key Interlock Solenoid Test

SRS components are located in this area. Review the SRS component locations, precautions, and procedures before doing repair or servicing.

1. Remove the driver's dashboard lower cover (see DASHBOARD CENTER PANEL REMOVAL/INSTALLATION ) and lower steering column cover.
2. Disconnect the steering lock assembly connector.
3. Turn the ignition switch to ACCESSORY (I).
4. Connect positive battery power to steering lock assembly connector terminal No. 4, and ground terminal No. 3. Make sure that the ignition key cannot be turned to LOCK (0). Disconnect battery power, and make sure that the key can be turned to LOCK (0) position and removed from the cylinder.
   Fig 1: Connecting Positive Battery Power To Steering Lock Assembly Connector Terminal No. 4, And Ground Terminal No. 3

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If the key interlock solenoid does not work correctly, replace the ignition key cylinder/steering lock assembly.
6. Install the driver's dashboard lower cover (see DASHBOARD CENTER PANEL REMOVAL/INSTALLATION ) and the lower steering column cover.