Start-up procedure and Diagnostic Menu

There are two ways to enter the diagnostic mode:

1. Connect the SCS connector (see FORCED STARTING OF DISPLAY  ) to the navigation service connector located in the trunk. Then turn the ignition switch to the ON (II). The display will go directly to the diagnostic menu screen shown below.
   NOTE: When finished troubleshooting, make sure to remove the SCS connector.
2. Turn the ignition switch ON (II). Use the navigation display hard buttons as described below:

   Make sure the battery is in good condition, then press and hold the three buttons (Menu, Map/ Guide, and Cancel), and keep them pressed for approximately 5 seconds. The display screen will go directly to the Select Diagnosis Items menu shown below.

   Fig 1: Diagnosis Screen Display - System Diagnostic Items Menu

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. After the display changes to the Select Diagnosis Items menu, select the item you want to check and the diagnostic will start. To return to the previous screen, select Return.
   • Navi System (Link)
   • Monitor Check
   • Unit Check
   • Car Status
   • XM (HIP)
   • GPS Information
   • Yaw Rate
   • Tire Calibrate
   • Functional Setup
   • Version