TPMS Control Unit Replacement

WARNING: This page is about a different variant/trim than selected.

NOTE: Make sure the TPMS control unit mounting bracket is not bent or twisted as this may affect its communication with the initiators and the tire pressure sensors.

Turn the ignition switch to LOCK (0).
Remove the headliner (see HEADLINER REMOVAL/INSTALLATION ).
Disconnect the TPMS control unit connectors (A).

Fig 1: TPMS Control Unit Connectors, TPMS Control Unit And Bracket With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the TPMS control unit (B) from the bracket (C).
Install the TPMS control unit in the reverse order of removal.
Connect the HDS, and memorize the tire pressure sensor IDs (see MEMORIZING THE TIRE PRESSURE SENSOR ID ). Do not memorize the IDs automatically.