Rod Bearing Cap Torque

Rod Bearing Cap Torque






Line up the mark (A) on the connecting rod and cap, then install the cap.

Apply new engine oil to the bolt threads and flanges
Torque the bolts (B) to 20 Nm (2.0 kgf-m, 14 ft. lbs.)






Mark the connecting rod (A) and bolt head (B) as shown.
Tighten the bolt until the mark on the bolt head lines up with the mark on the connecting rod (turn the bolt 90°).

NOTE: Remove the connecting rod bolt if you tightened it beyond the specified angle, and go back to the beginning of the procedure. Do not loosen it back to the specified angle.