Engine Electrical
ENGINE ELECTRICAL SPECIFICATIONS
| Item | Measurement | Qualification | Standard or New | Service Limit |
|---|---|---|---|---|
| Ignition coil | Rated voltage | 12V | ||
| Firing order | 1-3-4-2 | |||
| Spark plug | Type | NGK: IZFR6K13 DENSO: SKJ20DR-M13 |
||
| Gap | 1.2-1.3 mm (0.042-0.051 in.) | |||
| Ignition timing | At idle Check the red mark | M/T(in neutral) | 8 ± 2° BTDC | |
| A/T(in N or P position) | 8 ± 2° BTDC | |||
| Drive belt NOTE: At engine cold condition | Deflection with 98 N (10 kgf, 22 lbf) applied mid way between pulleys | With A/C | Used belt: 5.5-8.5 mm (0.22-0.33 in.) | |
| New belt: 3.5-5.0 mm (0.14-0.20 in.) | ||||
| Without A/C | Used belt: 7.5-10.5 mm (0.30-0.41 in.) | |||
| New belt: 4.5-6.0 mm (0, 18-0.24 in.) | ||||
| Tension (measured with belt tension gauge) | Used belt: 441-588 N (45-60 kgf, 99-132 lbf) | |||
| New belt: 980-1, 078 N (100-110 kgf, 220-242 lbf) | ||||
| Alternator | Output | At 13.5 V and normal engine temperature | 90 A | |
| Coil (rotor) resistance | At 68°F (20°C) | 1.84-2.10 Ω | ||
| Slip ring O.D. | 22.7 mm (0.89 in.) | 21.2 mm (0.83 in.) | ||
| Brush length | 19.0 mm (0.75 in.) | 5.0 mm (0.20 in.) | ||
| Brush spring tension | 3.3-4.1 N (0.34-0.42 kgf, 0.75-0.93 lbf) | |||
| Starter | Output | 1.0 kW | ||
| Commutator mica depth | 0.50-0.80 mm (0.020-0.031 in.) | 0.20 mm (0.008 in.) | ||
| Commutator runout | 0.02 mm (0.001 in.) max. | 0.05 mm (0.002 in.) | ||
| Commutator O.D. | 28.0 mm (1.10 in.) | 27.0 mm (1.06 in.) | ||
| Brush length | 14.0-14.5 mm (0.55-0.57 in.) | 9.0 mm (0.35 in.) | ||
| Brush spring tension | 13.7-17.7 N (1.40-1.80 kgf, 3.09-3.97 lbf) | |||