How to Retrieve a DTC: Notes

The heater control panel has a self-diagnostic function. To run the self-diagnostic function, do the following:

1. Set the mode control dial on the Vent position.
2. Turn the ignition switch to ON (II).
3. Within 5 seconds after turning the ignition switch on, press the recirculation control switch the required number of times depending on the recirculation indicator status:
   • If the indicator is ON, press the recirculation control switch 5 times.
   • If the indicator is OFF, press the recirculation control switch 6 times.

   The recirculation indicator will come on for 2 seconds, then blink the Diagnostic Trouble Code (DTC) to indicate a faulty component. If no DTCs are found, the indicator will not blink after the initial 2 seconds light.

   Fig 1: Identifying Heater Control Panel Parts Locations

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
   Fig 2: Identifying DTC Indication Pattern (DTC 2)

   Courtesy of AMERICAN HONDA MOTOR CO., INC.