LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2009 >> Element SC, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Navigation System (V6)) >> System Description >> Navigation Display Unit Inputs and Outputs for 28P Connector
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Navigation Display Unit Inputs and Outputs for 28P Connector

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Honda Crosstour, 2014 Honda Crosstour, 2013 Honda Crosstour, 2012 Honda Crosstour, and 2011 Honda Accord Crosstour. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Navigation Display Unit Inputs And Outputs For 28P Connector
G06420633Courtesy of AMERICAN HONDA MOTOR CO., INC.

Navigation Display Unit 28P Connector 

VOLTAGE SPECIFICATION

Terminal Number Wire Color Terminal Name Description Voltage (about) Symptom
1 Not used Not used -- -- --
2 WHT CAMERA V (VCC supply) Power source for rearview camera 8V If open: When put into reverse, the navigation screen goes black (backlight still operation)
If short to ground: When put into reverse, the navigation screen goes black (backlight still operative).
3 BLK CAMERA V GND (Ground camera) Ground for camera signal 0V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
4 GRY(1) CAMERA SH (Shield camera) Shield for terminals No. 2, No. 3, No. 16, and No. 17 0V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
5 BLK GND (Ground) Ground for display unit (G701) 0 V If open: No change to display.
If short to ground: No change to display.
6 RED G-SIG 1 (Green signal) Green color signal 0.7 V AC If open: Green color missing (see RGB COLOR  diagnosis).
If short to ground: Green color missing (see RGB COLOR  diagnosis).
7 WHT R-SIG 1 (Red signal) Red color signal 0.7 V AC If open: Red color missing (see RGB COLOR  diagnostic).
If short to ground: Red color missing (see RGB COLOR  diagnosis).
8 Not used Not used -- -- --
9 GRN SECURITY+ Security signal from passenger's MICU 0 V If open The security system will set, and will not trip when display is removed.
If short to ground: The security system will set, and will not trip when display is removed.
10 GRN ECU BUS+ (GA-Net) (Display bus positive) Data bus+ (GA-Net) 0-5 V pulses average 2.5 V depends on bus traffic If open: Navigation buttons do not work.
If short to ground. Navigation buttons do not work.
11 GRY(1) GA BUS SH (GA-Net) Shield for terminals No. 12 and No. 26 0 V If open: No change to display.
If short to ground: No change to display.
12 RED GA BUS+ (GA-Net bus positive) Data bus-t-(GA-Net) 0-5 V pulses average 2.5 V depends on bus traffic If open: Navigation buttons do not work.
If short to ground' Navigation buttons do not work.
13 PUR ACC (Accessory) Power source for accessory Battery voltage at ACCESSORY (I) If open: Display and buttons do not work.
If short to ground: Blows fuse No. B18(7.5 A) in the driver's under-dash fuse/relay box.
14 WHT +B (+B power source) Continuous power source Battery voltage If open: Screen completely off (no backlight visible).
If short to ground: Blows fuse No. A15(10 A) in the under-hood fuse/relay box.
15 BRN CAMERA ADPT (Adaptive camera) Control signal for rearview camera 0V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
16 RED GND (RC) (Ground camera) Ground for rearview camera signal 0V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
17 GRN CAMERA VCC (Video camera) Video signal for rearview camera 0.3 V If open: No change to rearview camera image.
If short to ground. No change to rearview camera image.
18 Not used Not used -- -- --
19 BLK(1) SH SIG 1 (Shield signal) Shield for terminals No. 6, No. 7, No. 20, No. 21, and No. 22 0 V If open. No change to display
If short to ground: No change to display.
20 BRN C-SIG 1 (Composite signal) Composite video (vertical/horizontal) synchronizing signal 0.3 V AC If open: Picture rolls horizontally, colors still visible.
If short to ground. Picture rolls horizontally, colors still visible.
21 YEL B-SIG 1 (Blue signal) Blue color signal 0-1 VAC If open: Blue color missing (see RGB COLOR  diagnosis).
If short to ground. Blue color missing (see RGB COLOR  diagnosis).
22 BLU SIG 1 GND (Ground signal) Ground for color signal 0V If open: No change to display.
If short to ground: No change to display.
23 YEL SECURITY- Security signal to audio unit 0V If open: The security system will set, and will not trip when display is removed.
If short to ground: The security system will set, and will not trip when display is removed.
24 RED ECU BUS-(Display bus negative) Data bus- (GA-Net) 0-5 V pulses average 2.5 V depends on bus traffic If open: Navigation buttons do not work.
If short to ground: Hard and touch buttons work OK.
25 GRY(1) ECU BUS SH (Shield ECU bus) Shield for terminals No. 10 and No. 24 0V If open. No change to display.
If short to ground. No change to display.
26 GRN GA BUS-(GA-Net bus negative) Data bus- (GA-Net) 0-5 V pulses average 2.5 V depends on bus traffic If open/short: System Links Radio icon and/or XM icon shows red.
GA-Net related system do not work.
27 Not used Not used -- -- --
28 GRY ILL+ (Illumination positive) Parking light on signal from dash and console lights Lights On: Battery voltage Lights Off: 0 V If open: When brightness=Auto, night mode for the display is inoperative when lights on.
If short to ground: Blows fuse No. C6 (7.5 A) in the passenger's under-dash fuse/relay box.
(1) The shielded wires have a heat-shrink tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire listed on the schematic.