Alternator Reassembly
- If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N.m (11.0 kgf.m, 81.0 lbf.ft).
- Remove any grease or any oil from the slip rings.
- Put the rear housing assembly and drive-end housing/rotor assembly together, torque the four through bolts.
- Push in the brushes (A), then insert a pin or drill bit (B) (about 1.6 mm (0.06 in.) diameter) to hold them there.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Install the brush holder, and pull out the pin.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Install the end cover.
- After assembling the alternator, turn the pulley by hand to make sure the rotor rotates smoothly and without noise.
- Install the alternator (see INSTALLATION
) and drive belt (see DRIVE BELT REPLACEMENT
).