LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2010 >> Element SC, Automatic >> Repair and Diagnosis (Single Page) >> General Information >> Reset Procedures >> Maintenance Reminder Light (Reset Procedures) >> Tire Pressure Monitor System Reminder >> TPMS Reminder Reset - Procedure 03 >> Calibration - Models Without TPMS Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Calibration - Models Without TPMS Switch

  1. Make sure the tires are inflated to the specified tire pressure listed on the doorjamb label. Vehicle must be stopped with the transmission in neutral (M/T) or P or N (A/T, CVT).
  2. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
  3. Use ARROW buttons (right side of steering wheel) to select VEHICLE SETTINGS, then press the SEL/RESET button. TPMS CALIBRATION appears on the display.
  4. Press the SEL/RESET button. The display switches to the customization setup screen, where you can select CANCEL or CALIBRATE.
  5. Use ARROW buttons to select CALIBRATE, then press the SEL/RESET button. CALIBRATION STARTED screen appears, then the display returns to the customization menu screen
    NOTE: If the CALIBRATION FAILED TO START message appears, repeat steps 4 and 5.
  6. Calibration is completed after driving 31 to 62 mph (50 to 100 km/h), steadily without much acceleration or deceleration for about 30 minutes.
scientia non olet · About LEMON Manuals