Immobilizer-Keyless Control Unit Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Honda Crosstour, 2014 Honda Crosstour, 2013 Honda Crosstour, 2012 Honda Crosstour, and 2011 Honda Accord Crosstour. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or servicing.

Remove the steering column covers (see COLUMN COVER REMOVAL/INSRALLATION ).
Disconnect the 7P connector (A) from the immobilizer-keyless control unit (B).

Fig 1: Identifying 7P Connector And Immobilizer-Keyless Control Unit
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the two screws and the immobilizer-keyless control unit.
Install the immobilizer-keyless control unit in the reverse order of removal.
After replacement, register the immobilizer-keyless control unit (see IMMOBILIZER KEY REGISTRATION ), and make sure the immobilizer system works properly.
Program all of the customer's keys/keyless transmitters (see IMMOBILIZER KEY REGISTRATION ).