Audio Remote Switch Test

SRS components are located in this area. Review the SRS component location (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS section before doing repairs or service.

1. Remove the driver's airbag assembly (see DRIVER'S AIRBAG REPLACEMENT ).
2. Disconnect the cable reel 20P connector (A).
   Fig 1: Identifying Cable Reel 20P Connector Terminals

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Measure the resistance between the terminals No. 9 and No. 10 in each switch position according to the table.
   RESISTANCE CHART
   
   

   Position	Resistance
   No button pressed	About 10 kΩ
   MODE	About 3.7 kΩ
   CH (+)	About 1.7 kΩ
   CH (-)	About 775 Ω
   ↑ (VOL.UP)	About 357 Ω
   ↓ (VOL.DOWN)	About 100 Ω

4. If the resistance is not as specified, replace the audio remote switch (see AUDIO REMOTE SWITCH REPLACEMENT  ).