Self-diagnostic Function
NOTE:
This procedure should be used only if HDS is unavailable.
To run the self-diagnostic function, do the following:
- Turn the ignition switch to ON (II).
- Press and hold the HFL BACK button for more than 5 seconds.
- When the HandsFreeLink system enters the self-diagnostic function, the following will occur.
- If the system has not completed testing for DTCs, the HandsFreeLink system says "The hands free system test is in progress".
- If there is no DTC, the HandsFreeLink system says "The hands free system is OK".
- If there is any DTC, the HandsFreeLink system says "The hands free system needs to be serviced".
- The self-diagnostic function ends when the units returns to idle state.
NOTE:
The self-diagnostic function can only be initiated while the HFL is in an idle state.