LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2011 >> Insight Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transmission (CVT) >> CVT Input Shaft (Drive Pulley) Speed Sensor Replacement
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

CVT Input Shaft (Drive Pulley) Speed Sensor Replacement

  1. Remove the air cleaner (see AIR CLEANER REMOVAL/INSTALLATION ).
  2. Disconnect the CVT input shaft (drive pulley) speed sensor connector, then remove the CVT input shaft (drive pulley) speed sensor (A).
    Fig 1: O-Ring And CVT Input Shaft (Drive Pulley) Speed Sensor With Torque Specifications
    G06430126Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install a new O-ring (B) on a new CVT input shaft (drive pulley) speed sensor, then install the CVT input shaft (drive pulley) speed sensor in the transmission housing.
  4. Check the connector for rust, dirt, or oil, and clean or repair if necessary then connect the connector securely.
  5. Install the air cleaner (see AIR CLEANER REMOVAL/INSTALLATION ).
scientia non olet · About LEMON Manuals